Drag Spinning Fishing

Why a new line to my fishing pole to Unraveling?

I'm spinning reel hub, and just put a pretty good quality (new) line, however, when casting and lock / line with the opening of the spring off and pull the knob to adjust like crazy. What is the reason? It may be bad? New line was significantly larger when the cylinder is purchased and the spinning reel, which is my pole is smaller, so maybe it just fits right change??? HELP!

Hey, the main reason the fact that the wheel does not unspool to the extent that it is because it is too much line you spool. although the reel says it holds 100 yrds, 200 yrds, 500yrds, and the line does not have any reason to make that much of it. I think My rule of thumb is do I change out of my line once a year. during the year, how much line you're actually going to use. usually breaking off huge amounts of line or popping a line probably do not use up to a maximum of 50-yard line. and also think of how far you throw your line. i dont usually toss out up to 30 yrds. I usually pitch to attract 20-30 feet away. so i dont have a lot of buses. even if the coil to successfully hold the line 200 yrds you throw far, and use it a lot. If the reel is full, and the course of the year and change away from our line, to see all the lines, which have a cast. I tend to buy a 300-500 yard line and reel, I usually finish, that coil around 4 years. waste not want to be. I am only in my visor spool about half way and that is more than a lot. I know it seems rather be a whole new line reel, but it is not needed. I know that rambled a lot so I hope this helps you out a bit of good luck Kalas is a safe and remember to share the experience

Fishing Reel Tips. Shimano Fighting Drag Explained

[affmage source="ebay" results="6"]Drag Spinning Fishing[/affmage]